Vladimir Kopta received his B.Sc. degree in electrical and electronics engineering from the university of Belgrade, Serbia in 2011 and his M.Sc. and Ph.D. degrees from the Swiss Federal Institute of Technology in Lausanne (EPFL), Switzerland, in 2013 and 2018, respectively. Since 2018 he has been a research and development engineer at the Swiss Center for Electronics and Microtechnology (CSEM), where he has been involved in the design of low-power circuits and systems. The two focus areas of his work are RF circuits for wireless communications and power management for battery powered systems on a chip.

• 1. Introduction 2. Linear Regulators 3. DC–DC Converters 4. Auxiliary Circuits 5. Conclusion

Select Guide Rating

Vladimir Kopta received his B.Sc. degree in electrical and electronics engineering from the university of Belgrade, Serbia in 2011 and his M.Sc. and Ph.D. degrees from the Swiss Federal Institute of Technology in Lausanne (EPFL), Switzerland, in 2013 and 2018, respectively. Since 2018 he has been a research and development engineer at the Swiss Center for Electronics and Microtechnology (CSEM), where he has been involved in the design of low-power circuits and systems. The two focus areas of his work are RF circuits for wireless communications and power management for battery powered systems on a chip.

• 1. Introduction 2. Linear Regulators 3. DC–DC Converters 4. Auxiliary Circuits 5. Conclusion

Select Guide Rating

Vladimir Kopta received his B.Sc. degree in electrical and electronics engineering from the university of Belgrade, Serbia in 2011 and his M.Sc. and Ph.D. degrees from the Swiss Federal Institute of Technology in Lausanne (EPFL), Switzerland, in 2013 and 2018, respectively. Since 2018 he has been a research and development engineer at the Swiss Center for Electronics and Microtechnology (CSEM), where he has been involved in the design of low-power circuits and systems. The two focus areas of his work are RF circuits for wireless communications and power management for battery powered systems on a chip.

• 1. Introduction 2. Linear Regulators 3. DC–DC Converters 4. Auxiliary Circuits 5. Conclusion

Select Guide Rating