3D Printing in Medicine

A Practical Guide for Medical Professionals

Häftad, Engelska, 2018

1 309 kr

Beställningsvara. Skickas inom 11-20 vardagar. Fri frakt för medlemmar vid köp för minst 249 kr.

This book describes the fundamentals of three-dimensional (3D) printing, addresses the practical aspects of establishing a 3D printing service in a medical facility, and explains the enormous potential value of rendering images as 3D printed models capable of providing tactile feedback and tangible information on both anatomic and pathologic states. Individual chapters also focus on selected areas of applications for 3D printing, including musculoskeletal, craniomaxillofacial, cardiovascular, and neurosurgery applications. Challenges and opportunities related to training, materials and equipment, and guidelines are addressed, and the overall costs of a 3D printing lab and the balancing of these costs against clinical benefits are discussed. Radiologists, surgeons, and other physicians will find this book to be a rich source of information on the practicalities and expanding medical applications of 3D printing.

Produktinformation

Utgivningsdatum2018-05-18
Mått178 x 254 x undefined mm
FormatHäftad
SpråkEngelska
Antal sidor138
FörlagSpringer International Publishing AG
ISBN9783319871912

Tillhör följande kategorier

Medicinsk bildbehandling inom Medicin
Medicin: icke kliniska discipliner inom Medicin
Förlossningsvård inom Medicin
Neurokirurgi inom Medicin

Frank J. Rybicki, MD, PhD, is Professor and Chair of Radiology at the University of Ottawa and The Ottawa Hospital. Dr. Rybicki introduced wide-area detector CT to radiology in 2007, focused on cardiac computed tomography. Dr. Rybicki was the founding and first Chairperson of the Radiological Society of North America Special Interest Group on 3D printing and is the Editor-in-Chief of 3D Printing in Medicine. Gerald T. Grant, DMD, MS, FACP received his D.M.D. degree from the University of Louisville, School of Dentistry in 1985 and his specialty training in Maxillofacial Prosthetics from the Naval Postgraduate Dental School, Bethesda, Maryland in 1999. He is a Diplomat of the American Board of Prosthodontics. Dr. Grant has over 15 years of experience in the use of digital design and 3D printing in customized medical and dental care in both research and application. He directed the development and was Service Chief of the 3D Medical Applications Center, Department of Radiology, at Walter Reed National Military Medical Center, one of the first and largest in-hospital services, providing medical models, surgical guides, and custom medical/dental devices world-wide to US military facilities for Wounded Warrior care. He is currently retired after 33 years from the United States Navy and is a Professor and Interim Chair of the Oral Health and Rehabilitation Department at the University of Louisville School of Dentistry where he has developed collaborative research teams with the Schools of Medicine, Engineering, and Dentistry for Advanced Digital Applications in the design and fabrication of medical devices for craniofacial reconstruction, dental restoration and rehabilitation, and recently in bio-printing/bio-fabrication.

Introduction.- 3D printing technologies.- Post-processing of DICOM images.- Establishing a 3D Service in your medical facility.- The 3D printing lab in a radiology practice.- Training and education of a 3D medical printing technologist.- Cranio-Maxillofacial 3D printing.- 3D printing in Neurosurgery and Neurointervention.- Cardiovascular 3D printing.- Musculoskeletal 3D printing.- Virtual Surgical applications.- Design and Fabrication of Customized Patient Devices.- 3D printing in Radiation Oncology.- FDA interests in the 3D printing of medical models and devices.- Bioprinting.